1/31/2024 0 Comments Helicon remote canon powershot![]() It should detect the camera in a couple of seconds. A message “Start pairing devices” will be displayed if the camera has established network connection successfully. If an error message is displayed, you have either entered a network access key incorrectly or you need to enter network settings manually (consult with you network administrator in this case)Ģ. – enter network access key (password), press MENU to confirm – select “Enter 8-63 ASCII characters”, press OK Note that Wi-Fi module may not detect networks that occupy wireless channel higher than 7 – select your network from the list, press OK. – select “Remote control (EOS Utility)” mode ![]() – if there is “Exit” option – select it and press ОК, then enter Wi-Fi function again Automatic parameters will most likely work, if not – contact your network administrator. – select “Enter 8-63 ASCII characters”, press ОК Note that WFT module may not detect networks that occupy wireless channel higher than 7 – if it’s a wireless network – select your network name from the list. – EOS Utility (this is the only mode Helicon Remote will work with) Set Wi-Fi module up and connect the camera to the network. Helicon Remote is able to connect to cameras via network cable or though Wi-Fi connection.Ĭanon WFT and Nikon WT modules support both ethernet wired and Wi-Fi connection.Ĭanon 6D has embedded Wi-Fi module, ethernet connection is not supported.ġ. Helicon Focus Help - Helicon Remote Helicon Remote and network cameras: setup guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |